How To Bleed A Diesel Engine - PassageMaker

How To Bleed A Diesel Engine

Publish date:

Once upon a time, we used to “flow fuel,” as they say in boat-testing parlance. That meant disconnecting supply and return fuel lines, splicing in fuel-flow meters, and then running electrical cables from the meters to a computer that would precisely calculate fuel burn. Only one time did I make a bad connection on a hookup and allow air to enter the supply line of an engine, a mistake that promptly airlocked the engine and summarily shut it down. The steps I took to get things going again are fairly universal:


First, back off the bleed screw on top of the secondary fuel filter—three or four turns is usually enough. Some engines, like the one shown, have two secondary filters.

Second, begin working the lever (plunger or whatever) on the fuel lift pump (an engine-mounted component downstream of the primary fuel filter) until bubbles stop forming under the bleed screw and solid fuel comes out. Use rags to keep things neat and then tighten the bleed screw back up. Do the second secondary if necessary.

Screen shot 2015-06-22 at 1.30.26 PM

And third, repeat the bleeding process via the bleed screw on the injector pump (unless it has self-purge capability) and then again (depending on your manufacturer’s recommendations) on each individual injector.

Procedure varies from engine to engine, so consult your operator’s manual for the exact one.

This post originally appeared here.